|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
HOW TO INSTALL REFRIGERATOR
3. How to Control the Amount of Water Supplied to Icemaker.
3-1. Confirm the amount of water supplied to the icemaker.
1. Pull out the ice bank in the upper part of the freezer compartment. Caution : � Do not put hands or tools into the chute to confirm the operation of geared motor. it may damage refrigerator or hurt hands.) � Check the operation of motor with its operation noise.
2
1
2. Apply electricity after connecting water pipe. 1) Press test switch under the icemaker for two seconds as shown below. 2) The bell rings(ding~dong) and ice tray rotates and water comes out from the icemaker water tube. 3) The water shall be supplied two or three times into the tray. The amount of water supplied for each time is small. Put a water container under the ice tray and press test switch. 4) When ice tray rotates, the water in it will spill. Collect the spilt water and throw away into the sink. 5) When ice tray has finished rotation, water comes out from the water tube. Confirm the amounts of water in the ice tray. (refer to fig. The optimum amount of water is 110cc)
Confirm the amount of water
Ice maker
Test Switch Too much Optimum level Too little
* It is acceptable if the adjusted level of water is a bit smaller than optimum level.
|
|
|
> |
|
